Notifications
Clear all
Topic starter
05/04/2016 10:47 am
Hello,
I am calibrating my test setup and I have a question about the distance beteween antenna and target.
I would like to have 1 meter between my hyperlog 7060 antenna and my DUT and test it at 868 MHz (for esample).
My question is where should I take the reference point for the 1m distance? on the tip of the antenna? on the SMA connector?
on the middle of the antenna?
Regards, Ramon.
07/04/2016 1:09 pm
It is allwas the antenna front but dont forget to keep 10! times the wavelength away!
Snip
Topic starter
21/04/2016 12:32 pm
Hello,
Thanks for your kind reply.
Then I will take the nose/tip/front of the antenna as my reference point.
10 times? my lab is not so big !! I thought 3 times lambda was enough, is it not?
Regards, Ramon.
21/04/2016 11:27 pm
You can try but to be 100% on the safe side use 10 times.
Snip
Share: