USB calibration dat...
 

USB calibration data export for HyperLOG & BicoLOG X or UBBV  

  RSS

Moderator
(@moderator)
Member Admin
Joined: 10 years ago
Posts: 1048
21/06/2013 4:30 pm  

All "X" antenna include a high gain preamplifier. Every preamplifier is individually calibrated. The calibration data (gain) of this preamplifier can be downloadad as a CSV file via USB. This helps you to calibrate the antenna with a NON Aaronia Spectrum Analyzer.

Download CALIBRATION DATA OF THE PREAMP ONLY:
First you need to install the MCS software 1.7.0 BETA3 or higher.
After installation start the MCS software.
Connect the USB port of the BicoLOG X or HyperLOG X preamp to your PC
A "SPECTRAN" driver will be installed (can take some seconds)
After installation go to SPECTRAN > Connect (DONT use the Play button!)
After a view seconds the preamp will show up in the "Available Devices" list
Select the Preamp and click on the now active "Connect" button.
The calibration data will now be downloadad to the MCS, this can take a while, depending on the amount of data.
After transfer you will get a pop up message with the name of the downloaded calibration data. Close this window and go to "Calibration".
You will find the new calibration data in "External Preamplifier".
Now you can select the file, click on right hand download symbol and export the data (CSV format).

Download typical TOTAL ANTENNA CALIBRATION DATA (ANTENNA & PREAMP):
First you need to install the MCS software 1.7.0 BETA3 or higher.
After installation start the MCS software.
Go to "Calibration".
You will find a list of all available Aaronia antenna with typical calibration data at "Antenna".
Select the antenna of interest, click on right hand download symbol and export the data (CSV format).

Snip


Quote
Share: