Fixing a firmware crash (no display)  

  RSS

Moderator
(@moderator)
Member Admin
Joined: 10 years ago
Posts: 1048
31/08/2010 10:15 am  

If your SPECTRAN shows no display after a firmware crash please use this instruction to reset it:

    Unplug the batterie
    Unplug the power supply
    Connect the SPECTRAN with the PC via USB cable
    Connect the power supply again to the SPECTRAN
    Press ENTER and ON at the same time on the SPECTRAN. The SPECTRAN will now connect to the PC but the SPECTRAN will show no display. If it doesn't connect, try above stepps again until it connects.
    Finally please update the firmware again and it should work fine. Do NOT! use the LCS software for the firmware update!
    Activate factory reset in the menu of the SPECTRAN[/list:u:2gqjmp2h]

Snip


Quote
likhobory
(@likhobory)
New Member
Joined: 10 years ago
Posts: 1
19/01/2011 10:57 am  

I can't connect to HF after firmware crash
unfortunatelly usb-cable was loose, can I use another standart mini-usb-cable instead of native one?


ReplyQuote
stb
 stb
(@stb)
Trusted Member
Joined: 10 years ago
Posts: 84
19/01/2011 11:14 am  

I can't connect to HF-6080 after firmware crash
unfortunatelly usb-cable was loose, can I use another standart mini-usb-cable instead of native one?

Should work fine for firmware updates, but may not work for measurements using the PC Software.

PGP
Homepage


ReplyQuote
Share: