New Calibration Required
I was read post, but when i was read that need calibration after upgrade firmware, i was image i can make calibration alone by SMA Resistor 50ohm (WHY DONT WAS WRITE THAT SURE WILL NEED CALIBRATION FROM FACTORY???!!!!!!! a lot person dont make it sure ! ) and sure dont know i must send my Spectran to factory again
Now how i cna solve my problem? How much cost for make new Calibration ? I image a lot money, and is not is good idea that now a lot person ned send all Aronia to company and spend money again for little mistemake about aaronia firmware that make this error.
The "New Calibration Required" message appeared immediately after I installed the software upgrade. I'm assuming that it was caused by the update, as mentioned in previous posts. Can I install an older version of the software to reclaim my calibrated status, or did the upgrade trash that old information?
That would make no sense since the new firmware modifies the old calibration file.
Anyway if you get the message your calibration simply was older then 2 years. The new firmware will check this, older versions did not.
In that case your calibration was not valid and you anyway would need a new recalibration (calibration period is 2 years).
So, the big question is:
Are the results of the displayed values any different than they would have been before the software upgrade? Are the results just not guaranteed to be calibrated (more than 2 years past cal date), or are they wildly different than they would have been if I had not applied the firmware update?