MCS and NF  

  RSS

Wooders
(@wooders)
Eminent Member
Joined: 9 years ago
Posts: 30
02/08/2012 2:47 pm  

I am using MCS 1.4.2 and an NF-5030 with firmware 1.0.

I connect OK to the NF but when I try to set the frequency to 0.5 kHz, it will only set it to 500kHz (0.5MHz).
Shortly after this the MCS stops responding and crashes.

Are there any suggestions please?

The original Point and Click Interface was a Smith and Wesson.


Quote
mm_dev
(@mm_dev)
Member Admin
Joined: 8 years ago
Posts: 287
03/08/2012 10:44 am  

That's a bug in the 1.4.2 version (using wrong frequency conversion for NF), please use 1.4.1 until this is fixed.


ReplyQuote
Share: