Notifications
Clear all
Topic starter
09/06/2017 4:05 pm
I am using a SPECTRAN V5 80200 Hand Held unit and would like to remote control the unit. Is this possible and how would i need to configure the RTSA Suite PRO ?
No problem. All you need is to set up a HTTP network by using the HTTP blocks of the RTSA:
Set up the SERVER (this is the PC where the SPECTRAN is connected). See attached a sample config.
Then setup the CLIENT on a second PC. See attached a sample config.
Connect both PCs via network e.g. ethernet cable and type in the IP address of the SERVER PC to the CLIENT block under "Connection -> Server" (defaul entry is "localhost").
Press "Start" and it should run
Snip
Share: