Notifications
Clear all
Topic starter
08/02/2013 3:26 pm
Hello.
I have used a serial terminal to send commands to Spectran HF-6060 under windows.
Now I am trying to do the same for linux, however the device is not recognised as USB2Serial.
Any help?
08/02/2013 3:38 pm
Not quite sure what you're talking about. The Spectran protocol is binary, so you'll have some problem when trying to use it over a serial terminal. The device should be listed in Linux in the /dev filesystem, the actual name will vary based on distribution and connected USB devices. It is however not supposed to be accessed as a serial terminal (I assume you were accessing it using the Ftdi VCP driver on Windows).
Share:
