Notifications
Clear all
Topic starter
17/10/2012 2:02 pm
Is there a detailed specification for the DC-Blocker please?
I need to carry out measurements using the NF-5030 down to 1kHz so we would need to know the loss at this frequency.
The original Point and Click Interface was a Smith and Wesson.
23/10/2012 3:10 pm
We allready use a quite big capacitor (470nF) so the DC blocker will work even at quite low frequencies but at 1kHz you will have a very high loss. I have some data at higher frequency points which i can give you:
23MHz = 0,1dB
10MHz = 0,5dB
4MHz = 3dB
etc.
As you can see you would have a very high loss at 1kHz.
Snip
Share: