Notifications
Clear all
Topic starter
04/03/2014 2:53 pm
hello:
i am going through the manual and am on section 5.0.I have the charger plugged into the wall scoket and the wall socket power is on.
i press the "2" key and the 5035 briefly says POWER then changes to PTESLA. It is in SPECTRUM mode. the display reads 0.000 and the spectrum display is not sweeping. Even if I place the unit right on top of the PSU, its the same.
It also says UNCAL above the PTESLA display.
It appears i am doing something incorrctly, any idea what i am doing wrong?
cheers,
john
04/03/2014 6:46 pm
Set the attenuator to 0dB....
BTW: The included switching power supply for sure will only have very low magnetic fields in the 50/60Hz range since it contains no transformer...
Snip
Share: