V4 noise floor calibration setup  

  RSS

JFTN
 JFTN
(@jftn)
New Member
Joined: 6 years ago
Posts: 3
26/01/2014 10:46 pm  

About the calibration level noise floor with a load of 50 ohms.
Spectran Analyzer v4.
Internal amplifier should it be activated for this operation to take into account the noise factor?
Regards


Quote
Moderator
(@moderator)
Member Admin
Joined: 9 years ago
Posts: 1048
27/01/2014 9:21 am  

Yes, allways calibrate the complete setup you want to use afterwards.

Snip


ReplyQuote
joaoo
(@joaoo)
New Member
Joined: 5 years ago
Posts: 1
04/09/2014 1:20 pm  

When I use the function Callrun with the calibration resistor connected the signal disappear and I have to restart the program and disconnect/reconnect the HF-60105 V4X to see the signal again.
Why it happens?


ReplyQuote
Moderator
(@moderator)
Member Admin
Joined: 9 years ago
Posts: 1048
06/09/2014 12:47 am  

Thats normal because the new data need to get reloaded after a system restart.

Snip


ReplyQuote
Share: